Products

Fitted onto the bottom section of the mast, below the goose neck, to attach the vang system to the bottom section of the mast. Suits all three Lase...

Fitted onto the top of the top section of the mast to protect it and the sail from damage. Also used as a boom end plug.

The outhaul sleeve is a metal clew tie down which fits around the boom and slides up and down, amazingly, with almost no friction and noise. The us...

The premium deck cover is designed to keep your ILCA deck and deck fittings away from the worst of the sun and weather. Premium covers are manufact...

The PSA / Laser Foil Bag is a handy bag for carrying almost all of your laser equipment. It will fit the rudder, centreboard, tiller and tiller ext...

The Premium hull cover is designed to keep your ILCA dinghy's hull protected when being transported and stored. Premium covers are manufactured wit...

This is the plain rudder blade that is an integral part of the boat. It facilitates steering combined with the tiller, tiller extension and rudder ...

Includes the bolt, nut and bushing to hold the rudder blade inside the rudder head

Rudder comes complete with rudder blade in rudder head connected with the rudder bushing set.

The rudder gudgeons are fitted in pairs to the stern of the boat and the rudder is held in place by them.

The rudder head holds the rudder blade in place and can be used to rotate the rudder blade. It also connects the rudder blade to the tiller, and ho...

The rudder lift stop prevents the rudder from lifting up while it is sitting in the rudder gudgeons.

The 'self bailer' or 'venturi' is situated at the rear of the cockpit where it sucks water from the cockpit above a certain boat speed. This is the...

This kit allows you to repair a broken 'self bailer' or 'venturi'. Contents Include: Flap and closing mechanism Rubber O-Rings to keep the flap shu...

The spar carrier is the most time efficient accessory you can invest in. They mean you no longer need to tie your spars down for travel and storage...

This tiller comes with a wedge at the back to fit into the rudder head, a cleat in the middle to tie off the rudder, and a the universal tiller ext...

The tiller retaining pin is an integral part of the rudder system as it holds the tiller in the rudder head and prevents it from slipping out.

The tiller wedge fits onto the end of the tiller and provides the tiller with a tight fit inside the rudder head. <

Top mast section to suit all three laser sail sizes.Comes complete with all fitting, ready to put straight onto the boat. *This item is considered ...

The Turbo pack is the necessity of all modern laser sailors. it increased the purchase on most control lines and provides efficient smooth blocks w...

ILCA class approved vang system with Harken blocks. The complete set includes: 1 x ILCA vang block - built by Harken; 1 x 16 mm Harken single top b...

Black rubber plug for the self bailer (venturi). Has a hole Has a hole in the middle to push over the self bailer shaft.

New ILCA® Lower Vang Unit   FEATURES Lowest friction ILCA® vang unit available. HHL sheave for the high load primary sheave. Easy cleating and re...

230mm Sail Numbers to suit most Off The Beach Sailing boats under 3.5m.   These include: Optimist ILCA 4   Colours include Blue, Red, Black (oth...

300mm Sail Numbers to suit most Off The Beach Sailing boats and Trailer Sailors between 3.5m and 8.5m.   These include: ILCA 6 ILCA 7 Sharpies 505...