ILCA (Laser)

The 'self bailer' or 'venturi' is situated at the rear of the cockpit where it sucks water from the cockpit above a certain boat speed. This is the...

Commonly known as the bung, this is the screw in plug for the hole on the aft of the boat. Stamped with RWO it suits most of the newer Laser hull.

This fairlead is the aluminium version of the fairlead used on the stern of the boat to provide maximum turning points for the traveller. They are ...

Black rubber plug for the self bailer (venturi). Has a hole Has a hole in the middle to push over the self bailer shaft.

The Grabrails are notably used to grab in instances of capsizes and rolling the boat. They are located on the upper sides of the cockpit walls. Sol...

The bow eye is fitted to the bow of the boat and is used to tie the boat to something, to facilitate towing or as a place to secure the centreboard...

The hole that exists in the rear of the cockpit is used as a venturi. This brass fitting set is fitted in order to use the venturi.

A pad placed underneath the hiking strap plate at the rear of the centreboard case which is used to hold the centreboard in place.

The rudder lift stop prevents the rudder from lifting up while it is sitting in the rudder gudgeons.

The rudder gudgeons are fitted in pairs to the stern of the boat and the rudder is held in place by them.

This kit allows you to repair a broken 'self bailer' or 'venturi'. Contents Include: Flap and closing mechanism Rubber O-Rings to keep the flap shu...

Fitted to the rear wall of the cockpit to hold the hiking strap.

These are the New PSA / Laser hiking straps, the same straps that are supplied with new boats. Previously we have supplied them in the blue/black c...